JennAir Induction Cooktop Code E_03: Something Pressing on the Panel

What E_03 means

E_03 on JennAir induction cooktops, such as the JIC4536KS and JIC4536XS, means pressure is being put on the control panel. An object, liquids or soil on the touch area are pressing the keys and causing the error. Remove anything left on the control area and wipe debris from the panel surface. The cooktop will accept input again once the area is clear.

Common causes of E_03

An object resting on the control area
Spilled liquid across the touch keys
Dried soil or residue on the panel

✓ One safe check you can try

1. Switch the cooktop off. 2. Remove anything resting on the touch controls. 3. Wipe the panel with a soft damp cloth and dry it completely. 4. Wait about a minute, then touch ON/OFF. 5. If E_03 persists on an empty, clean panel, call us.

! Why to stop there

This is almost always a cleaning task, so a paid visit would be unnecessary.
Pressing hard on the keys to clear it can scratch the glass.
A clean, dry panel that still shows E_03 needs the touch circuit tested by a technician.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Cooktop codes

FC E0JennAir Induction Cooktop Code FC E0: Supply, Wiring or Induction Module FC E1JennAir Induction Cooktop Code FC E1: Is It the Touchpad or Its Wiring? FC E4JennAir Induction Cooktop Code FC E4: Harness Between Touchpad and Module FC LFJennAir Radiant Cooktop Code FC LF: Left Front Element or Its Wiring FC LRJennAir Radiant Cooktop Message "FC LR": Left Front Hotplate or Wiring FC RFJennAir Radiant Cooktop Code FC RF: Right Front Element or Its Wiring FC RRJennAir Radiant Cooktop Code FC RR: Right Rear Cooking Area Is in Question F42JennAir Radiant Cooktop Code F42: Board That Powers the Elements

E_03E_03 questions

What can trigger E_03?

Anything that presses on the panel: a pan, lid, towel, spilled liquid or soil. The control reads constant pressure as an error and stops taking input.

Do I need a service call for E_03?

Usually not. Remove the cause, clean and dry the panel, then try again. Call us only if the code stays on a clean panel. Keep the area dry afterward.

Can wet fingers cause it?

Yes, water on the keys can act like a press. Wipe the panel dry with a microfiber towel and try again. If E_03 continues on a dry panel, call us.