JennAir Wall Oven Code F3 E4: probe or attachment came loose mid-cycle

What F3 E4 means

On JennAir built-in wall ovens such as the JJW2830DS and JJW9830DDP, F3 E4 usually appears when the meat probe or a power attachment has come out of its socket. Depending on the model, the oven sees the probe or attachment as dislocated while a cycle is running. You will see the code, and the cycle may pause or stop, even though the oven itself may be perfectly healthy.

Common causes of F3 E4

Meat probe not fully pushed into its receptacle
Power attachment not seated while in use
Probe or attachment socket dirty or worn so contact is intermittent

✓ One safe check you can try

1. Ask whether the probe or a power attachment was in use. 2. Let the oven cool, then push the probe plug fully into its receptacle; the socket location varies by model. 3. Seat any power attachment firmly according to the attachment's directions. 4. Restart the cycle. If F3 E4 still shows with nothing attached, call us.

! Why to stop there

A socket that no longer grips the probe needs a proper part, not bending.
If the code appears with nothing plugged in, the cause is deeper in the circuit.
Using a damaged probe in a hot oven can burn your hand.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

FC E7JennAir Wall Oven Code FC E7: Oven did not connect to router FC E8JennAir Wall Oven Code FC E8: Registration error FC E9JennAir Wall Oven Code FC E9: Wi-Fi power module wiring Feature Not AvailableJennAir Wall Oven Message "Feature Not Available": Follow the Prompt on the Display Flashing Time, Clock, 12:00, Power Loss or Enter TimeJennAir Wall Oven Display Flashing Time or 12:00: Set the clock after power loss Locked, Lock or LocJennAir Wall Oven Display Locked, Lock or Loc: Controls and door are locked Press Cancel to ResetJennAir Wall Oven Message "Press Cancel to Reset": Clear and power cycle Probe or Insert ProbeJennAir Wall Oven Display Probe or Insert Probe: Meat probe needed

F3 E4F3 E4 questions

Why did F3 E4 appear in the middle of roasting?

The oven noticed that the probe or power attachment lost its connection. A loose plug, a nudge to the probe, or a worn socket is all it takes to trigger the notice.

Is F3 E4 a serious problem?

Usually not. It is often a seating issue that you can fix by pressing the plug in fully. If it appears with nothing connected, the oven needs a closer look.

What if the probe still will not register?

Try a different cooking mode to confirm the oven heats normally. If only the probe fails, the probe or its receptacle is probably worn, and we can quote a replacement in writing.