JennAir Pump Ice Machine JUIFX15HX for Custom Panels
The JUIFX15HX combines the two features that most affect service on an ice machine: a drain pump and an articulating hinge for a custom panel. It is made for kitchens and bars where the floor drain is not close, and the panel makes it disappear into the cabinets.
On these calls we test the pump and float first, then follow the discharge hose for kinks. We also look at hinge wear, because a drooping door lets warm air in and melts the bin. Inlet valve flow and scale on the evaporator come next. Before we leave, we run the pump and watch the discharge so you know the repair holds.
We give you the price in writing before starting, and our repair has a 30-day workmanship warranty.
It pushes melt water out through a discharge line, so the machine can drain to a point higher than its base. If the pump stops, water collects inside and the unit may shut off.
Yes. If the hinge lets the door sag, the gasket stops sealing and warm air reaches the bin, so ice melts and clumps. We realign the hinge and check the seal along the full edge.
If water pools in the base, suspect the pump or hose. If the bin stays empty but the base is dry, suspect the supply. We test both in one visit and tell you which it is.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
