JennAir JXW8736DS Canopy Hood Repair
The JXW8736DS is a 36-inch wall-mount canopy hood, installed against the wall above a range. Because the vent runs behind or above the canopy, the duct connection is out of sight and often overlooked.
We make sure it is not. After testing the controls and lamps, we check the blower, then follow the air path to the damper, duct and cap. If the fan is noisy, the wheel and filters get the closest look. Replacement parts are only used when a part fails testing. Since this hood is identified by its 36-inch width and model number, we confirm the controls, lamp type and blower once it is open, and price any part from what we actually see. That keeps the estimate accurate on an older unit.
Every job begins with a written price, and a 30-day workmanship warranty follows.
A wobble is typically an uneven wheel, with grease clumped on one side. We clean or replace the wheel and tighten its mount. We rebalance or replace it, depending on what the test shows.
Yes. A duct that was lengthened, bent or reduced during remodeling cuts airflow. We inspect the duct run if the hood performs worse after construction. Rebuilding a vent path correctly makes a bigger difference than a new motor.
Turn the fan and lights off, and let everything cool. Removing filters does not require cutting breaker power, but we do that during repairs. We turn the power off at the breaker when we open the hood.
Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.
