JennAir Dishwasher Code F9E2: Drain motor error

What F9E2 means

On JennAir dishwashers such as the JDB9200CWX or JDAF3924RX, F9E2 is a drain motor error, and it often shows up on new installations. Make sure the garbage disposer knockout plug was removed, check the disposer and drain for clogs, straighten any kinked hose, and verify the hose is routed correctly inside the frame. A kinked or clogged hose can cause poor drainage or none.

Common causes of F9E2

Garbage disposer knockout plug not removed on a new install
Drain hose kinked, clogged or misrouted
Drain motor failing
Clog in the disposer or drain line

✓ One safe check you can try

1. Check the disposer and drain for clogs and run the disposer clear. 2. If this is a new install, confirm the knockout plug was removed. 3. Straighten the drain hose if you can see a kink. 4. Clean the filter. 5. Cycle the power and run a short cycle. If F9E2 stays, call us.

! Why to stop there

Checking hose routing inside the frame means access behind the unit.
A motor problem looks the same as a clog from outside.
Water left in the tub can back up into the sink.
We trace the drain path first and quote any motor work in writing.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

F8E4JennAir Dishwasher Code F8E4: Check for water and leaks after installation F8E5JennAir Dishwasher Code F8E5: Fill valve stuck open F9E1JennAir Dishwasher Code F9E1: Long drain time FAE4 or F10E4JennAir Dishwasher Code FAE4 or F10E4: Diverter valve error FAE5 or F10E5JennAir Dishwasher Code FAE5 or F10E5: Diverter leak H2OJennAir Dishwasher Code H2O: Not detecting water Sanitize Light FlashingJennAir Dishwasher Message "Sanitize Light Flashing": Sanitize Temperature Not Met E:18JennAir Flush-Mount Code E:18: Water supply too low or missing

F9E2F9E2 questions

Why does a new dishwasher show F9E2?

Most often the disposer knockout plug was not removed or the hose is kinked. Those are install details, and fixing them clears the problem without any part.

Is the drain hose routing important?

Yes. It should sit on the correct side and inside the frame, with the high loop where required. Water pushed back from the sink is another sign that the route is wrong.

Do I need the drain motor replaced?

Only if the drain path is clear and the code still returns. We test the motor first, tell you what we find, and give a written price with a 30-day workmanship warranty.