Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent JennAir specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 766-5788 Request a Technician
Model library · JennAir Cooktop

JED3536WS

JennAir JED3536WS Repair for 36-Inch Radiant Downdraft Cooktops

JennAir cooktop

Most common issues on this model

  1. A radiant element that will not heat or heats only part of its ring
  2. Switch that clicks but gives no output
  3. Downdraft motor squeal or reduced pull
  4. Smoke lingering over the cooktop because the filter is clogged

Five radiant elements across 36 inches give the JED3536WS room for several pans at once, and the integrated downdraft means it can stand in an island with nothing overhead. If your kitchen is built around that layout, the cooktop works hard and the cabinet below it takes the heat and grease that come with it.

Our first job is to find which of the five zones is misbehaving. A ring that glows only along one side tells us the element is wearing out, while a zone that never warms often has a switch problem. We measure rather than guess, so you do not pay for a part that was fine.

After the cooktop surface, we turn to the downdraft: filter, blower wheel and the duct run. Written pricing comes first, every time, and the finished work is covered by a 30-day workmanship warranty.

Key features

  • 36-inch electric radiant downdraft cooktop
  • Five radiant elements
  • Downdraft ventilation
→Codes

Error codes this model can show

JED3536WSJED3536WS questions
How can I tell if my JED3536WS needs a new element or a new switch?

If the element looks damaged or has visible breaks, it is the element. If it looks intact but never warms, the switch is a likely cause. We check resistance on the element and output from the switch to be sure.

Why does smoke hang over the cooktop even with the downdraft on?

A loaded filter or a blower that has slowed down is the usual reason. Grease coats the wheel and cuts airflow. We clean or replace what we find and check that the duct is clear.

Is it normal for the surface to stay warm after I turn it off?

Yes, radiant glass holds heat for a while, and that is normal. If a zone stays hot or glows with the control off, however, the switch may be stuck, and you should call us.

Book a visit

Book repair for your JED3536WS

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

☎ Call the desk ▤ Request a Technician