JennAir Flush-Mount Code E:06: Door hall sensor cannot be read

What E:06 means

E:06 on a JennAir flush-mount dishwasher for European cabinets, such as the JDB9600AW, means the control cannot read the Hall sensor that reports whether the door is closed. The machine stops in whatever position it was in and does nothing further. The usual reasons are a broken wire to the sensor, a power module problem, or a failed sensor. Nothing else moves until that signal returns.

Common causes of E:06

Wire to the door Hall sensor interrupted
Power module not reading the sensor signal
Hall sensor itself failed

✓ One safe check you can try

1. Open the door fully and close it with a firm push until it latches. 2. Look at the door edge and the tub opening for a dish, a utensil or a rack part that stops the door from closing flat. 3. After a one-minute rest at the breaker, restore power. 4. Start a short program. If the machine still does nothing and E:06 stays, call us.

! Why to stop there

The sensor and its wire run behind the door and inside the control area, where owners should not reach.
A bent door hinge or loose panel can look like a sensor problem, and only a hands-on check separates them.
Forcing the door or taping a sensor to fake a closed door is unsafe because the program then runs with the door unlatched.
We find the wire, module or sensor before any part is ordered, and the price comes first in writing.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

Sanitize Light FlashingJennAir Dishwasher Message "Sanitize Light Flashing": Sanitize Temperature Not Met F8E4JennAir Dishwasher Code F8E4: Check for water and leaks after installation F8E5JennAir Dishwasher Code F8E5: Fill valve stuck open F9E1JennAir Dishwasher Code F9E1: Long drain time F9E2JennAir Dishwasher Code F9E2: Drain motor error FAE4 or F10E4JennAir Dishwasher Code FAE4 or F10E4: Diverter valve error FAE5 or F10E5JennAir Dishwasher Code FAE5 or F10E5: Diverter leak H2OJennAir Dishwasher Code H2O: Not detecting water

E:06E:06 questions

The door seems shut. Why does the machine still not start?

The control does not see the door; it relies on a Hall sensor signal. If that wire or sensor is not reporting, the machine behaves as if the door were open and stays stopped in its last position.

Can a loose item in the tub cause E:06?

An item that holds the door slightly open can cause door-related trouble, so check it first. But E:06 itself is listed for a wire, module or sensor problem, so a clear door that still shows E:06 needs a technician.

Is it a quick repair?

Often yes, if the wire or sensor is the cause. We diagnose it on the first visit, quote the price in writing, and stand behind the work with a 30-day workmanship warranty.