JennAir Dishwasher Code F2E1: Stuck key on the console

What F2E1 means

On JennAir TriFecta dishwashers such as the JDTSS246GL or JDPSG244PS, F2E1 means the console reads a button as pressed all the time, which is a stuck key or a console error. The control stops accepting normal commands. You may see the dishwasher beep, refuse to start, or show F2E1. A power cycle is the first step to try. It is not a water or drain problem.

Common causes of F2E1

Key on the console stuck or sensing constant contact
Console or touch panel defective
Moisture or residue on the panel

✓ One safe check you can try

1. Wipe the control panel with a dry soft cloth and make sure nothing is resting on the buttons. 2. Open and close the door. 3. Pause the power at the breaker for a minute, then bring it back. 4. Try to start a short cycle. If F2E1 returns, call us rather than pressing buttons repeatedly.

! Why to stop there

A stuck key can mean the console panel has failed, which is a replacement part.
Pressing many times will not free a failing sensor.
Water getting behind the panel can damage the board.
We check the console and quote in writing before replacing it.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

F8E4JennAir Dishwasher Code F8E4: Check for water and leaks after installation F8E5JennAir Dishwasher Code F8E5: Fill valve stuck open F9E1JennAir Dishwasher Code F9E1: Long drain time F9E2JennAir Dishwasher Code F9E2: Drain motor error FAE4 or F10E4JennAir Dishwasher Code FAE4 or F10E4: Diverter valve error FAE5 or F10E5JennAir Dishwasher Code FAE5 or F10E5: Diverter leak H2OJennAir Dishwasher Code H2O: Not detecting water Sanitize Light FlashingJennAir Dishwasher Message "Sanitize Light Flashing": Sanitize Temperature Not Met

F2E1F2E1 questions

Is something physically stuck?

It can be. A bit of residue or a bulge under the panel can keep a key active. Wipe it and try again. If nothing is visible, the console may have developed a defect.

Why can't I start a cycle?

The control reads the stuck key as a constant command, so it ignores or blocks normal presses. Cycling the power resets that reading for a moment.

Does the door still lock?

The door latch works as usual, but the machine may not start. We diagnose the console, quote in writing, and offer a 30-day warranty on the repair.