JennAir Dishwasher Code F8E2: Fill valve electrical error

What F8E2 means

On JennAir dishwashers such as the JDAF3924RX or JDPSG244PS, F8E2 reports an electrical error at the fill valve, the part that lets water into the tub. The control cannot operate the valve normally, so the dishwasher may not fill. The recommended steps are to check the drip tray and the inlet connection for leaks, then cycle the power. It is an electrical message, not a drain or detergent problem.

Common causes of F8E2

Fill valve coil or wiring failing
Loose or leaking inlet valve connection
Control not driving the valve

✓ One safe check you can try

1. Turn off the water supply tap if you can reach it. 2. If you can see under the front, check the drip tray and the inlet connection for any water or drips. 3. Shut the breaker off, wait a minute, then bring it back on again. 4. Open the water tap and run a short cycle. If F8E2 returns, call us.

! Why to stop there

The valve is wired and plumbed together, so a leak and an electrical error can overlap.
Disconnecting the inlet can spill water into the cabinet.
Water near a live valve is a shock hazard.
We inspect the valve and connections and quote before replacement.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

F8E4JennAir Dishwasher Code F8E4: Check for water and leaks after installation F8E5JennAir Dishwasher Code F8E5: Fill valve stuck open F9E1JennAir Dishwasher Code F9E1: Long drain time F9E2JennAir Dishwasher Code F9E2: Drain motor error FAE4 or F10E4JennAir Dishwasher Code FAE4 or F10E4: Diverter valve error FAE5 or F10E5JennAir Dishwasher Code FAE5 or F10E5: Diverter leak H2OJennAir Dishwasher Code H2O: Not detecting water Sanitize Light FlashingJennAir Dishwasher Message "Sanitize Light Flashing": Sanitize Temperature Not Met

F8E2F8E2 questions

What is the drip tray?

It is a small tray under the inlet area that catches drips. If it holds water, the inlet connection is leaking and should be dealt with before you run the dishwasher again.

Is F8E2 a leak code?

Not by itself. It is an electrical error on the fill valve. A leak check is only part of the first look because water and electrics share the same area.

Can you fix it in one visit?

Usually, if the valve is on hand. Sometimes we need to order it. Either way you get a written price first, and the work is covered by a 30-day workmanship warranty.