JennAir Dishwasher Code FAE5 or F10E5: Diverter leak

What FAE5 or F10E5 means

On JennAir dishwashers such as the JDAF3924RX or JDB9200CWX, FAE5 or F10E5 means a diverter leak. The control suspects water is escaping around the diverter. The official steps are to check for leaks under the dishwasher, make sure all water connections are secure, press Cancel twice, and try to start a new cycle. If the code returns, schedule service. Water on the floor is a common sign.

Common causes of FAE5 or F10E5

Diverter valve leaking
Loose water connection under the dishwasher
Seal around the diverter worn

✓ One safe check you can try

1. Turn off the water supply tap. 2. Look under and in front of the dishwasher for water. Mop up any you find. 3. Check that the water connections are tight, without forcing them. 4. Press Cancel twice, then try a new cycle. 5. If the code returns, stop and call us.

! Why to stop there

A leak under the unit can damage the floor and cabinet.
The diverter is in the base area.
Water and wiring share the lower space.
We find the leak, quote in writing and repair it with a 30-day warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

F8E4JennAir Dishwasher Code F8E4: Check for water and leaks after installation F8E5JennAir Dishwasher Code F8E5: Fill valve stuck open F9E1JennAir Dishwasher Code F9E1: Long drain time F9E2JennAir Dishwasher Code F9E2: Drain motor error FAE4 or F10E4JennAir Dishwasher Code FAE4 or F10E4: Diverter valve error H2OJennAir Dishwasher Code H2O: Not detecting water Sanitize Light FlashingJennAir Dishwasher Message "Sanitize Light Flashing": Sanitize Temperature Not Met E:30JennAir Flush Mount Code E:30: internal error from overvoltage

FAE5 or F10E5FAE5 or F10E5 questions

Why press Cancel twice?

Two presses end the current cycle and clear the message, so you can see whether a fresh cycle starts normally. Cancel is a safe button to use here, but do not keep pressing it.

Is a diverter leak serious?

It can be, because water is leaving its normal path. We recommend stopping use until the leak is traced, since a slow drip can ruin a cabinet floor over a few weeks.

What if I see no water?

A small leak may only show while the machine runs. Dry the area, watch it during a short cycle, and book a visit if the code returns or you spot any damp.