Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent JennAir specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 766-5788 Request a Technician
Error code · Range

JennAir Range Message “Demo Mode”: Showroom setting is on

On JennAir electric, gas and dual-fuel ranges with electronic control, like the JES1750FS or JIS1450DS, Demo Mode means the control is in demonstration mode. It is meant for showroom floors on a 120 V connection, and…

Low risk · DIY check OK
Request a Technician(713) 766-5788
Code
Demo Mode
Appliance
Range
Brand
JennAir
Warranty
30-day workmanship

What Demo Mode means

On JennAir electric, gas and dual-fuel ranges with electronic control, like the JES1750FS or JIS1450DS, Demo Mode means the control is in demonstration mode. It is meant for showroom floors on a 120 V connection, and it lets the control features be shown without the oven turning on. While it is active, the oven will not work. You will see the display respond but nothing heats.

Common causes of Demo Mode

  • Demonstration mode was switched on from the control
  • The range was set up from a display model
  • Keys were pressed in a sequence that activates the mode
✓ One safe check you can try

1. Do not expect heat while the message is shown. 2. Check the owner's guide or control guide for your model for the steps to leave demonstration mode. 3. Turn the range off at the breaker for one minute and back on. 4. Try a short Bake. 5. If the oven still does not heat, call us.

! Why to stop there
  • This is a setting, so a part replacement would be money wasted.
  • Exact steps differ by model, and wrong key presses may not help.
  • If the setting will not turn off, the control needs a technician.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.
→Same appliance

Other Range codes

FEE7JennAir Range Code FEE7: Main cavity broil element Flashing Time, Clock, 12:00, Power Loss or Enter TimeJennAir Range Display "12:00" or "Power Loss": Set the Clock After an Outage Indicator FlashingJennAir Range Cooktop Indicator Flashing: Keys Pressed or Controls Set Wrong Indicator or Hot Light OnJennAir Range Hot Light On: A Control or Element Is Still Hot Lo or PreJennAir Range Display "Lo" or "Pre": The Oven Is Warming Up LockJennAir Range Cooktop Control Lock: Unlock to Use the Surface Locked, Lock or LocJennAir Range Oven Display "Locked", "Lock" or "Loc": Unlock Controls and Door Press Cancel to ResetJennAir Range Message "Press Cancel to Reset": Clear the Alert
Demo ModeDemo Mode questions
Why is my new oven not heating?

If the display says Demo Mode, the control is in its showroom setting and keeps the oven from turning on. Once it is turned off per your guide, the oven can heat.

Is Demo Mode an error?

No. It is a feature, not a problem with the range. The oven stays off by design until the mode is turned off, and nothing needs to be replaced.

Can you turn off Demo Mode for me?

Yes. If you cannot find the steps for your model, call us. We can switch it off, test the oven, and give you a price in writing if anything else is wrong.

Book a visit

Still unsure about Demo Mode?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 766-5788
☎ Call the desk ▤ Request a Technician