JennAir Wall Oven Code 3d41: meat probe not detected

What 3d41 means

On JennAir built-in wall ovens including the JJW2830LL and JJW9830DDP, the 3d41 message asks you to verify the meat probe is securely inserted in the meat probe receptacle. Receptacle location varies by oven. The control displays 3d41 when it cannot find the probe signal during a probe cycle, and the cycle may pause. Once the probe seats properly, the cycle usually resumes with no repair.

Common causes of 3d41

Probe not seated in the receptacle
Probe cord or plug damaged
Receptacle dirty or damaged

✓ One safe check you can try

1. Use Cancel to end any cycle and pause a little while. 2. Inspect the probe cord for kinks or burn marks. 3. Wipe the plug and push it firmly into the receptacle. 4. Restart the cycle. If 3d41 persists, bake without the probe and call us.

! Why to stop there

A frayed probe cord can cause intermittent signals.
The receptacle sits inside a hot cavity and is not for DIY repair.
We confirm the price before beginning, and our work is warranted for 30 days.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

Feature Not AvailableJennAir Wall Oven Message "Feature Not Available": Follow the Prompt on the Display Flashing Time, Clock, 12:00, Power Loss or Enter TimeJennAir Wall Oven Display Flashing Time or 12:00: Set the clock after power loss Locked, Lock or LocJennAir Wall Oven Display Locked, Lock or Loc: Controls and door are locked Press Cancel to ResetJennAir Wall Oven Message "Press Cancel to Reset": Clear and power cycle Probe or Insert ProbeJennAir Wall Oven Display Probe or Insert Probe: Meat probe needed PUSH or PSHJennAir Wall Oven Display PUSH or PSH: Press start Sabbath, Sab, 5Ab, or 5A7JennAir Wall Oven Display Sabbath, Sab, 5Ab or 5A7: Sabbath mode is on FC E6JennAir Wall Oven Code FC E6: Wi-Fi power module

3d413d41 questions

Is 3d41 the same as 3d31?

All three probe messages carry the same instruction, to verify the probe is seated. The digits are the control's labels, and the checks are the same.

What if my probe looks fine?

Plugs can look fine and still have dirt or a weak contact. Try cleaning and reseating once. If it keeps failing, the probe or receptacle needs testing.

Is it okay to leave the probe in during self-clean?

No. The cleaning cycle is far too hot for the probe. Remove it before any self-clean and store it away from the heat. Leaving it in can melt the cord insulation and damage the receptacle.