JennAir Flush-Mount Code E:10: Zeolite drying heater circuit open

What E:10 means

E:10 on the JennAir flush-mount dishwasher for European cabinets, such as the JDB9600AW, means the machine runs without zeolite drying. The heating circuit for the zeolite drying unit is interrupted, or the fan module has a problem, or a wire is broken. It only applies to zeolite models and is listed in service mode. Dishes tend to finish damp. Nothing else is affected.

Common causes of E:10

Zeolite heater circuit interrupted
Fan module defective
Wire to the heater or fan broken

✓ One safe check you can try

1. Interrupt the power at the breaker for around a minute and restore it afterward. 2. Run a short program and open the door slightly afterwards to let moisture escape. 3. If E:10 comes back, keep using the machine for washing only, and call us. Do not open the panels or reach into the drying unit.

! Why to stop there

The circuit sits in the base of the machine behind panels.
Heater and fan wiring carries power, so it must be checked with proper tools.
A broken wire can look fine from the outside.
We find the interrupted point and quote the repair in writing first.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

F8E4JennAir Dishwasher Code F8E4: Check for water and leaks after installation F8E5JennAir Dishwasher Code F8E5: Fill valve stuck open F9E1JennAir Dishwasher Code F9E1: Long drain time F9E2JennAir Dishwasher Code F9E2: Drain motor error FAE4 or F10E4JennAir Dishwasher Code FAE4 or F10E4: Diverter valve error FAE5 or F10E5JennAir Dishwasher Code FAE5 or F10E5: Diverter leak H2OJennAir Dishwasher Code H2O: Not detecting water Sanitize Light FlashingJennAir Dishwasher Message "Sanitize Light Flashing": Sanitize Temperature Not Met

E:10E:10 questions

What is zeolite drying?

It uses a mineral that absorbs moisture and releases heat, so dishes dry without an exposed heater. E:10 means that system is not working and the machine skips it.

Do I have to stop using the dishwasher?

No. Washing still works. You may find the dishes wet at the end, so a towel or an open door after the program helps. Please do not rely on the damp results for plastics, which hold moisture longest.

Is the repair big?

It depends on the cause: a wire is a smaller job than a heater or fan module. We tell you the price in writing before work and give a 30-day workmanship warranty.