JennAir Dishwasher Code F1E1: Control module needs a power cycle

What F1E1 means

On current JennAir TriFecta-style dishwashers, such as the JDTSS246GL or JDPSG244PS, F1E1 points to the control module. It is a control electronics message, not a water or filter problem. The cycle stops, the display shows F1E1, and the Clean light may flash once, pause, then flash once again. The first recommended step is to cycle the power and see whether the message returns.

Common causes of F1E1

Control module reporting an internal error
Brief electrical disturbance that confused the control
Control module needing replacement if the message returns

✓ One safe check you can try

1. Press Cancel and close the door firmly. 2. Cycle the breaker once, leaving it off for a minute. 3. Start a short cycle. 4. If F1E1 is gone, carry on as normal. If it returns right away, stop using the machine and book a visit. Do not open the door panel or touch the control.

! Why to stop there

The control module is the brain of the dishwasher and testing it needs the panel off and power present.
Replacing a module on a guess is the costliest way to find out the cause was a power blip.
Frequent restarts can leave water in the tub.
We tell you what we find, quote in writing, then replace only what has failed.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

F8E4JennAir Dishwasher Code F8E4: Check for water and leaks after installation F8E5JennAir Dishwasher Code F8E5: Fill valve stuck open F9E1JennAir Dishwasher Code F9E1: Long drain time F9E2JennAir Dishwasher Code F9E2: Drain motor error FAE4 or F10E4JennAir Dishwasher Code FAE4 or F10E4: Diverter valve error FAE5 or F10E5JennAir Dishwasher Code FAE5 or F10E5: Diverter leak H2OJennAir Dishwasher Code H2O: Not detecting water Sanitize Light FlashingJennAir Dishwasher Message "Sanitize Light Flashing": Sanitize Temperature Not Met

F1E1F1E1 questions

Can I clear F1E1 myself?

Often yes, once. Cycling power is the official first step and clears a one-time confusion of the control. If F1E1 comes back, the module needs a technician.

What do the light flashes mean?

The Clean light can blink in two groups: one blink, a short pause, then one more. That is the same F1E1, just shown by light count rather than text on the display.

Is it expensive to fix?

It depends on whether the control itself needs replacing. We confirm that first, give a price in writing before we start, and back the repair with a 30-day workmanship warranty.