JennAir JMV Code E61: oven sensor circuit open

What E61 means

E61 is displayed by JennAir over-the-range microwave hoods such as the JMV9196CS or JMV8000 series when the oven sensor circuit reports an open condition to the control board. The sensor, the appliance control board or the wiring may be the cause. You will see E61 and the microwave may not heat or may stop partway. Treat the unit as unreliable for heated cooking until the sensor circuit is measured.

Common causes of E61

Oven sensor has failed open
Sensor wire or connector is loose or broken
Appliance control board is not reading the sensor

✓ One safe check you can try

1. Cancel the cycle and let the oven cool with the door open. 2. Wipe up spills from the cavity once cool. 3. Close the door and try a short cycle with water. 4. Shut the breaker off briefly and then turn it back on. 5. If E61 comes back, call us.

! Why to stop there

An open circuit needs a meter to locate.
A loose connector may look fine and still fail.
The sensor is mounted inside the housing.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Microwave codes

F8 E3JennAir Built-In Microwave Code F8 E3: one more cooling alert Sabbath, Sab, 5Ab, or 5A6JennAir Built-In Microwave Message "Sabbath, Sab, 5Ab, or 5A6": Sabbath Mode On F8 E4JennAir Built-In Microwave Code F8 E4: exhaust air sensor SEJennAir JMV Code SE: keypad problem F8E5JennAir JMV Code F8E5: exhaust air temperature sensor F9JennAir JMV Code F9: appliance or relay control board F9Q1JennAir JMV Code F9Q1: touch pad problem FC E1JennAir OTR Microwave Code FC E1: router connection timed out

E61E61 questions

Does E61 match E21?

They are similar open-circuit codes. E61 names an oven sensor, while E21 names a thermal sensor. The testing steps are alike, but the part differs.

What does open condition mean?

The control sees no connection through the sensor, as if its wire were disconnected. It then refuses to heat, since it has no temperature reading to rely on.

Can a spill cause E61?

Not by itself, but heat and spills near a sensor can damage it over time. Clean the cavity when it is cool, and call us if the code stays after the cleaning.