JennAir JMV Code E12: gas sensor circuit problem

What E12 means

JennAir over-the-range microwave hoods, including the JMV9196CS and the JMV8000 series, display E12 when there is a problem with the gas sensor or its wiring. The sensor measures vapor from cooking and supports the automatic sensor modes. Owners see E12 and those modes may not start or may stop early. Manual cooking often continues unaffected. The sensor reads cooking vapor, never the gas line of your home.

Common causes of E12

Gas sensor has failed
Wiring to the sensor is loose or damaged
Sensor reading is out of range

✓ One safe check you can try

1. Cancel the cycle and open the door to vent. 2. Clean the cavity and door seal once cool. 3. Cook by time and power rather than using sensor keys. 4. Switch off the microwave's breaker, wait, and switch it back on. 5. If E12 reappears, call us.

! Why to stop there

Wiring and the sensor have to be measured separately.
Replacing a sensor without checking the harness can repeat the code.
The sensor detects cooking vapor and not home gas.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Microwave codes

FC E8JennAir OTR Microwave Code FC E8: registration rejected, check the SAID number FCE8JennAir OTR Microwave Code FCE8: wrong appliance type or model chosen Flashing 0:00JennAir Countertop Microwave Message Flashing 0:00: Reset the Clock Flashing ":" or PF in displayJennAir OTR Microwave Message Flashing ":" or PF: Power Failure or Clock Off LOC or "L" or Padlock IconJennAir Microwave Message LOC, L or Padlock Icon: Control Lock Enabled Locked, Lock or LocJennAir Built-In Microwave Message "Locked, Lock or Loc": Control Lock On ":" or "." in displayJennAir Built-In Message ":" or "." in display: clock needs setting F8 E3JennAir Built-In Microwave Code F8 E3: one more cooling alert

E12E12 questions

Is E12 a safety warning about natural gas?

No. It concerns a cooking vapor sensor inside the microwave. If you smell gas anywhere in the house, leave and call the gas utility from outside.

Why did E12 appear while I was cooking?

Sensor programs read the sensor continuously. If the reading drops out or goes out of range, the control shows E12 and stops that program rather than guess when your food is done.

Can I clean the sensor myself?

Wipe the cavity walls when they are cool, but leave the sensor and housing to a technician. Reaching the sensor means opening the unit, which puts you close to high-voltage parts.