Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent JennAir specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 766-5788 Request a Technician
Error code · Range

JennAir Range Message “Feature Not Available”: Try Again or Disable Power

On JennAir electric, gas and dual-fuel ranges with electronic oven control, such as the JES1750FS or JDRP548W, this scrolling message appears when a problem is detected while you are programming a cook cycle. It tells you…

Medium · inspection needed
Request a Technician(713) 766-5788
Code
Feature Not Available
Appliance
Range
Brand
JennAir
Warranty
30-day workmanship

What Feature Not Available means

On JennAir electric, gas and dual-fuel ranges with electronic oven control, such as the JES1750FS or JDRP548W, this scrolling message appears when a problem is detected while you are programming a cook cycle. It tells you to follow the displayed directions: PRESS ENTER TO TRY AGAIN or DISABLE POWER TO CLEAR. The cycle you were setting will not start until you do.

Common causes of Feature Not Available

  • A condition detected while programming a cook cycle
  • A momentary control glitch that a power reset clears
  • A control problem if the message comes back every time
✓ One safe check you can try

1. Read the scrolling message to see which instruction it gives. 2. If it says PRESS ENTER TO TRY AGAIN, press Enter and set the cycle again. 3. If it says DISABLE POWER TO CLEAR, turn the range's breaker off for a minute and back on. 4. If the message returns on every setup, call us.

! Why to stop there
  • The message gives you the first fix, so a visit only makes sense if it repeats.
  • Repeated messages can come from the control, which needs testing.
  • We quote in writing before work.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.
→Same appliance

Other Range codes

FC E8Registration Error During App Setup: JennAir Range FC E8 FC E9JennAir Range Wi-Fi Power Module Reported Again (FC E9) FEE6JennAir Range Code FEE6: Main cavity bake element FEE7JennAir Range Code FEE7: Main cavity broil element Flashing Time, Clock, 12:00, Power Loss or Enter TimeJennAir Range Display "12:00" or "Power Loss": Set the Clock After an Outage Indicator FlashingJennAir Range Cooktop Indicator Flashing: Keys Pressed or Controls Set Wrong Indicator or Hot Light OnJennAir Range Hot Light On: A Control or Element Is Still Hot Lo or PreJennAir Range Display "Lo" or "Pre": The Oven Is Warming Up
Feature Not AvailableFeature Not Available questions
Which instruction should I follow?

Whichever the display shows: PRESS ENTER TO TRY AGAIN or DISABLE POWER TO CLEAR. Both aim to clear the problem detected while you were programming the cycle on the range.

Does it mean my oven is broken?

Not necessarily. It means something was detected while you were programming. If the message clears and stays away on the next try, the oven is most likely fine.

What if it appears again and again?

Then the cause is still there. Write down what you were setting and call us so we can check the control and give you a written price.

Book a visit

Still seeing Feature Not Available?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 766-5788
☎ Call the desk ▤ Request a Technician