JennAir Range Code F5 E5: Self-Clean temperature not reached

What F5 E5 means

On JennAir electric, gas and dual-fuel ranges like the JES1750FS and JIS1450DS, F5 E5 means the oven has not reached self-clean temperature after 30 minutes. The range suggests a problem with the door hinges or the door gasket letting heat escape. The clean cycle ends and the display shows the code. On JennAir wall ovens the same code refers to the door latch assembly and door switch instead.

Common causes of F5 E5

Door gasket worn, loose or out of place
Door hinges allowing the door to hang open slightly
Heating element or control not bringing the cavity up to temperature

✓ One safe check you can try

1. Press Cancel and wait for the oven to cool all the way down. 2. Inspect the door gasket for gaps, tears or pieces that have slipped out of place. 3. Check that the door closes squarely with no uneven gap. 4. Remove racks and spills, and reset power at the breaker. 5. Retry the clean cycle once.

! Why to stop there

A heat leak and a weak element look alike from the outside.
A damaged gasket can let heat damage nearby parts.
We quote in writing first and cover repairs for 30 days.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

Indicator FlashingJennAir Range Cooktop Indicator Flashing: Keys Pressed or Controls Set Wrong Indicator or Hot Light OnJennAir Range Hot Light On: A Control or Element Is Still Hot Lo or PreJennAir Range Display "Lo" or "Pre": The Oven Is Warming Up LockJennAir Range Cooktop Control Lock: Unlock to Use the Surface Locked, Lock or LocJennAir Range Oven Display "Locked", "Lock" or "Loc": Unlock Controls and Door Press Cancel to ResetJennAir Range Message "Press Cancel to Reset": Clear the Alert Probe or Insert ProbeJennAir Range Display "Probe" or "Insert Probe": Meat Probe Not Detected PUSH or PSHJennAir Range Display "PUSH" or "PSH": Press Start to Begin

F5 E5F5 E5 questions

Why 30 minutes?

The control waits 30 minutes for the cavity to reach self-clean temperature before it ends the cycle and shows the code, so a clean cycle that is losing heat stops by itself.

Can a dirty oven cause F5 E5?

Heavy soil does not usually trigger it. The listed suspects are the door hinges and the door gasket, which let heat escape, so look at the gasket for gaps before you retry.

Does this code mean the door latch failed?

On this range it does not. The same code on a wall oven names the latch assembly and door switch, which is why we always diagnose by appliance.